No Readings or Inaccurate Readings on Display - Breeze Pro LTV-WSDTH03 and LTV-WSDTH04
Why Does My LTV-WSDTH04 Sensor Read Inaccurately?
The thermo-hygro sensor reads the environment. Since your Temperature/Humidity readings come from the combination Wind/Temp/Humidity sensor they may occasionally be inaccurate if direct sunlight hits the sensor for prolonged periods.
If this is a common occurrence you can purchase an LTV-TH2 temperature sensor and replace the Temperature/Humidity Readings from the combo sensor.
How to Replace the TH Reading from the Wind TH Sensor with an LTV-TH2?
If the temperature is reading high, you have the option to replace the temp/humidity readings from the LTV-WSDTH and add an LTV-TH2 temp/humidity sensor to read in the OUTDOOR area of the display instead.
To Remove the LTV-WSDTH temp/humidity readings:
Press the SENSOR button once - the Station ID will show.
Press the SENSOR button again - ID WTH123 THW SENSOR will show.
Hold the MINUS (-) button for 5 seconds while viewing ID to delete ID WTH123.
To add a separate LTV-TH2 sensor:
After deleting the TH sensor built into the Wind Sensor (ID: WTH123), press the SENSOR button on the station to view the ID, then press the TEMP button to put the station into search mode.
Press the TX button on the add-on sensor.
After successful pairing, the Sensor Icon will show to indicate the reading is coming from separate TH sensor.
What Does a Reading of "Hi" or "Lo" Mean?
If your outdoor temperature reading shows “HI” or “LO”, check that your batteries are good.
Overpowered or underpowered batteries can cause this reading.
If batteries are good, replace the outdoor sensor.
If your temperature is fine but your humidity is reading “HI” or “LO” or dashes, your humidity may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
Why are there NO readings on my Weather Station Display?
Press and release the SENSOR button on the indoor display one time, if you see dashes for an ID contact us via our support form or chat. If you see an ID, proceed to the steps listed below.
- Bring the sensor 3-5 feet from the indoor display.
- Press and release the SENSOR button on the indoor display 3 times to view your sensor ID number. (Dashes may show for the ID)
- While viewing your sensor ID or dashes, hold the MINUS button for 5 seconds to delete the sensor ID and reset.
- Spin the wind cups on the sensor for 30 seconds.
Allow up to 3 minutes for the station to find the sensor.
If you still do not see wind speed or outdoor temperature readings, try a full factory reset:
- Hold the two outside buttons together for 5 seconds or until the station resets.
- Unplug AC cord from the display and press any button on the display 20 times before powering back up.
- Spin the wind cups on the sensor for 30 seconds.
- If the station was connected to Wi-Fi, you will need to reconnect. Open the La Crosse View app. go to Menu -> Connect Wi-Fi. Follow the on screen prompts to configure the Wi-Fi on your display.
If you still do not see wind speed or outdoor temperature readings, our support team can be reached at our support form.