No Readings on Display - Breeze Pro LTV-WSDTH01 Sensor

Press and release the SENSOR button on the indoor display one time, if you see dashes for an ID contact us via our support form or chat.  If you see an ID, proceed to the steps listed below.

If you are unable to get wind speed or outdoor temperature on your weather station:
- Turn the Breeze Pro Sensor (LTV-WSDTH01) to the OFF position.
- Place the sensor in an area where the solar panel can receive a full 24 hours of sunlight.
- After 24 hours of sunlight, turn the sensor ON and repeat the steps provided below. 

If you are still unable to get the wind/outdoor temperature readings:
- Bring the sensor 3-5 feet from the indoor display. Make sure that the switch on the bottom of the Breeze Pro Sensor (LTV-WSDTH01) is in the ON position.
- Press and release the SENSOR button on the indoor display 3 times to view your sensor ID number. (Dashes may show for the ID)
- While viewing your sensor ID or dashes, hold the MINUS button for 5 seconds to delete the sensor ID. (Dashes may show for the ID)
- Spin the wind cups on the sensor for 30 seconds. 
Allow up to 3 minutes for the station to find the sensor. 

If you do not see wind speed or outdoor temperature readings, try a full factory reset:
- Hold the LIGHT and WIND ALERTS buttons together for 5 seconds or until the station resets.
- Unplug AC cord from the display and press any button on the display 20 times before powering back up.
- Spin the wind cups on the sensor for 30 seconds.
- If the station was connected to Wi-Fi, you will need to reconnect. Open the La Crosse View app. go to Menu -> Connect Wi-Fi.  Follow the on screen prompts to configure the Wi-Fi on your display.  

Please Note: Using a non-rechargeable coin cell battery can potentially ruin the sensor. If the battery is replaced, ensure the replacement battery specifically states that it’s a ML2032 Rechargeable Battery.