Delete Sensor ID from Display/Replace Sensor

In the event you need to replace your sensor, you will first need to delete the old sensor ID from your station and remove batteries from your old sensor.

1. Remove batteries from your old sensor.
2. Press and release the SENSOR button to view your sensor ID number.
3. While viewing your sensor ID (for the sensor you are replacing), hold the MINUS button for 5 seconds to delete your old sensor ID. Dashes will show for the ID number.
4. Your station will search for a new sensor.
5. Install batteries in your new sensor and allow up to three minutes for your new sensor readings and ID to
   appear on your station.

Note: When replacing your Thermo-Hygro sensor, press the TX button (under the battery cover) to send a signal immediately. The Rain and Wind sensors do not have a TX button.