616-1410 / 616-12667 Projection and Backlight
This article applies to 616-1410, 616-1410V2, 616-12667 and 616-12667V2.
Projection will not stay on.
The projection will be continuously displayed if the AC cord is plugged into the wall. Please check that the AC cord is properly plugged in. On the unit, line the cord up with the hole and push it in firmly. Sometimes it helps to use a pen, as the opening is small. Once you are sure it is in correctly, remove the batteries. If the display goes blank, your AC cord is not solidly in place.
A unit that has a color display screen or is backlite will remain lite only if the AC cord is plugged into the wall. If the AC cord is not used the display will stay lite for 5 - 15 seconds and then go dark.
Projection Image/Options
1. Hold the projection button to enter the Projection Settings
2. Use the +/- buttons to change projection selection.
- Time only
- Indoor Temp only
- Outdoor Temp only
- Alternate Time + Indoor Temp + Outdoor Temp
3. Projection image will stay on last option selected.
Projection, Brightness and Rotation
Brightness:
Press the projection button to change the Projection Brightness (High, Low, or Off).
Rotation:
Use the Rotation Wheel on the back of the projection arm to change the projection orientation 270 degrees.
Tilt The Projection Arm:
The Projection Arm can tilt forward and backward to adjust the location of the projection image on a wall or ceiling.
How to adjust the backlight.
Press the SNOOZE/LIGHT button to adjust the backlight to adjust the backlight intensity. There are 4 levels, plus an off option.