LAM Sensor Registration
During the set up process you may experience trouble registering your sensor.
Start by:
- Place the registered gateway and sensor within 3 - 5 feet of each other.
- Remove the batteries from the sensor.
- Press the gray button on the sensor 25 times.
- Place new batteries in the sensor. Be sure to use a new, Brand Name Alkaline battery dated at least 7 years in advance (super, ultra, max, heavy duty and rechargeable types should be avoided). Place the batteries back into the remote sensor; making sure they are installed according to polarity.
- R11 or R22 should read on the LCD display for a couple of seconds followed by a 1 or dashes. If you see the temperature on the LCD display press and hold the gray button on the sensor for about 15 - 20 seconds until you see 18.88 and then return to step 2.
- Unplug the AC adaptor from the gateway for 15 seconds and then plug it back in.
- Once the red light on the gateway is solid, go to your account and select Register New Sensor.
- Firmly press and release the gray button on the gateway.
- Firmly press and release the gray button on the sensor. The sensor should start counting for about 10 - 20 seconds. (Example 101, 102, 103...)
- Firmly press and release the gray button on the gateway.
- Once you see the temperature on the LCD display select 'Submit" in the app or website.
- If you do not see the temperature on the LCD display repeat steps 8 - 11. Although this may not be typical these steps may need to be repeated 3 - 4 times.