WT-3102A, WT-3122B, WT-3122EH, WT-3122J, WT-3122K, WT-3122L
Looking for the manual for this item?
Click HERE to be directed to the product listings. Confirm the full model number of your item and click on the respective full product listing or the direct links to Parts/Sensors, Support, or Product Manual.
SET UP
- Select Time Zone and DST settings
- Insert 1 AA battery into the Battery Compartment.
- The hands will move to the 12 o’clock position and search for the WWVB Atomic Time Signal for up to 8 minutes. If no signal, after 8-10 minutes, clock will run from 12:00. The clock will continue to search for the WWVB Atomic Time Signal. Allow up to 5 nights for the clock to receive this transmission. For the best reception, place the clock on an exterior wall near a window with the front or back of it facing Fort Collins, CO.
Note: In certain areas, this clock may not be able to receive the WWVB reception due to signal strength or interference. In this case, your clock can be set manually until the Atomic Time Signal can be received.
MANUAL SET TIME
- Hold SET for 3 seconds to manually set your time.
- Press and hold SET again to move hands quickly.
- Press and release SET to move hands forward step by step.
Note: The Atomic Time Signal will override your manual setting if the transmission is received in the future.
RESET BUTTON
If the clock does not respond when trying to manually set your time, press the RESET button one time.
The hands will move to the 12 o’clock position and begin searching for the WWVB Signal again.